Coleman lantern restoration

Homesteading & Country Living Forum

Help Support Homesteading & Country Living Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

user 6493

Awesome Friend
HCL Supporter
Neighbor
Joined
Oct 25, 2016
Messages
6,474
I have a new hobby,,,I have taken up repairing old Coleman lanterns

what you need

1 gallon of white vinegar

and steel BB's

a bucket

a tooth brush

and most likely a new generator

disassemble the lantern you will have at least some rust,,,,,,,,,

soak all rusty parts in the vinegar

if the tank is rusty I like to pull the valve,fill with vinegar let all parts soak at least an hour,,,

I like to let them set over night most parts you can brush with the tooth brush and most if not all will come off,,

,the tank once you have soaked it pour it out,(I save the vinegar for my next Lantern) once you have drained it put a good amount of BB's in it and shake well put the lid on and your finger over the hole the valve was in or you will have BB's every where,,,,,the shaking does not take all that long 5 minutes will be enough for most lanterns

time to rinse it out dump the BB's into a container note all the crap that comes out with them,,,rinse several times to check for rust shine a light into the tank it will be pretty darn clean

the pump on the old ones are made of leather ,oil it and most will come back to life

reassemble with a new generator your lantern should be about as good as new

there are a few small parts that can go bad but I have yet to find one that needed more than cleaned and a new generator
 
Edited:
Good hobby Ghost and rewarding. I got a lot of Colman's here
A couple of my older one's below that we still use today, these two my uncles purchased new. I posted a picture while ago of a 1980s colman duel fuel stove in mint condition I picked up at a Salvation Army store for $12 bucks.

1958 Big Hat
IMG_1392.JPG


1953 413D (below it 1946 colman ranger 3 burner)
413d.jpg


$12 dollar stove
IMG_1362.jpg
 
Last edited:
I am learning as I go,,,,,,fuel caps are a problem,but new caps are out there and you can get replacement o-rings for them,,,also the on off valve has a fuel pick up tube attached that mixes the fuel with air,,I have 2 lanterns that these are clogged on you can hear air coming out but little to no gas,there are replacement parts out there $20 but you may be able to clean the old one,I have not taken one out to look at it
 
I am learning as I go,,,,,,fuel caps are a problem,but new caps are out there and you can get replacement o-rings for them,,,also the on off valve has a fuel pick up tube attached that mixes the fuel with air,,I have 2 lanterns that these are clogged on you can hear air coming out but little to no gas,there are replacement parts out there $20 but you may be able to clean the old one,I have not taken one out to look at it

We every season take the generator out of the lanterns and stoves and pull the filler and cleaning rod out and use a carbon cleaner (carbon-off) for all three parts inside generator housing, filler (spring), cleaning rod and use a pipe cleaner for inside the generator housing filled with carbon-off.
 
Back
Top