I need the best or second best (NASA level) "EPOXY" for a project. It can't shrink.

[Sourdough]

Needs to cure hard. And no shrinkage.

 

[Pearl]

NASA approves Master Bond Supreme 10HT! I googled that just now, you might Google it too and check it out!!

 

[randyt]

I like JB weld

 

[SoJer]

Needs to cure hard. And no shrinkage.

a) What are you Bonding? (just the Materials - don't need to 'break OPSEC' about yer Project.. asking, as..

b) Depending on the Materials to-be Bonded.. the "Best Non-Shrinking NASA-Level Bond" will be via one of the 'UV-Cure Epoxy's..

I used to use some of that stuff for building Optical sub-assemblies (in a 'Clean Room', under a stereo-microscope) for Laser-systems, where the Parts had to not only 'last' - thru Impact / Vibration / Heat/Cold - whatever - but to NOT 'shrink', down to tolerances of keeping a Laser-diode's beam focused in a particular-point thru a Crystal - to a couple "nm"s (that's Nano-meters And That stuff Did it. Yah, it's 'NASA-grade' alright..

..That's Also a reason it's the Top Choice for restorative Dental work - Keeping Porcelain / Zirconium, etc Crowns / Veneers, etc, in-place - thru heat / cold / Extreme Pressure from biting / chewing, etc... impacts from Errant Forks etc.. - and For Years, so..

Let me know more about yer 'Materials to Bond', and I'll check my sources / see if there's a Good match..

PS - Good 'Pro-grade Adhesives' resource for some Research: https://www.gluespec.com/

jd