- Joined
- Sep 4, 2020
- Messages
- 11,006
I have been slowly turning a room in our basement into a Hobbit Hole to satisfy a dream for @ThePrincess .
It is utilizing cove ceilings to achieve the curved ceiling look and feel.
I recently opened up a wall behind the steps leading upstairs to install a floor jack to support a major support beam. With most of paneling gone I can now size up what will be required to build book cases into the wall. Rather than drone on I will offer some images showing the challenge.
Looking at the steps with a light under the steps, the modesty panels suggest the steps are twisted down on the left side.
A level confirms the left stringer has dropped.
The wall on the left was literally smoke and mirrors.
Not a penny was wasted on proper studs and was cobbled together scraps of wood.
Yikes!
Then there is the section of wall on one side of the door. We don't need no stinking support beams. That wall makes about a 120 degree angle in the corner. All of this was done many years ago. Possibly during the depresion. Notice the rough sawn beam.
I will attempt to update this thread as I proceed.
Ben
It is utilizing cove ceilings to achieve the curved ceiling look and feel.
I recently opened up a wall behind the steps leading upstairs to install a floor jack to support a major support beam. With most of paneling gone I can now size up what will be required to build book cases into the wall. Rather than drone on I will offer some images showing the challenge.
Looking at the steps with a light under the steps, the modesty panels suggest the steps are twisted down on the left side.
A level confirms the left stringer has dropped.
The wall on the left was literally smoke and mirrors.
Not a penny was wasted on proper studs and was cobbled together scraps of wood.
Yikes!
Then there is the section of wall on one side of the door. We don't need no stinking support beams. That wall makes about a 120 degree angle in the corner. All of this was done many years ago. Possibly during the depresion. Notice the rough sawn beam.
I will attempt to update this thread as I proceed.
Ben